3 Replies Latest reply on Dec 9, 2016 8:34 AM by rhamnus

    Atlas 550 T1/PRI Connection and Port Mapping

    rhamnus New Member

      I am a new user, very new to this hardware.


      I have read the manual but I need help getting "over the hump".


      I have two 550 units I have connected back to back with a crossover T1 cable like this:


      I am communicating with both of them via terminal software.


      However, I don't see any indication that they are communicating with each other over the T1.  Connect it or disconnect it, network OK light stays green.


      My next step is to configure the octal E&M cards to go in one side and out the other.


      The manual is unclear to me on that also.


      If somebody can show me some baby steps to get these things working, I am sure it will all make much more sense.